Z93-Lab
Contents:
1. General Information
2. LibreSDR
3. Plutosky
4. Comparison
5. Terms of Use
Z93-Lab
Z93-Lab
View page source
Z93-Lab
Contents:
1. General Information
1.1. Hardware
1.2. Drivers and Libraries
1.3. Firmwares
1.3.1. Default firmware
1.3.2. Alternative firmwares
1.4. Analog devices links
1.5. “Extended capabilities”
1.5.1. Configuration
1.5.2. Available Modes
2. LibreSDR
2.1. Hardware
2.2. Firmware
2.3. Typical test setup
2.4. Port impedance
2.5. RX tests
2.5.1. Rx Frequency response
2.5.2. Rx Gain
2.5.3. Rx Bandwidth filter response
2.5.4. Rx Noise figure
2.5.5. Rx Spurious emissions
2.5.6. Rx Spurious reception
2.6. TX tests
2.6.1. Tx Frequency response
2.6.2. Tx Gain
2.6.3. Tx Filter bandwidth response
2.6.4. Tx LO leakage and Image
2.6.5. Tx Harmonics
2.6.6. Tx Spurious emissions
2.6.7. Tx (baseband) intermodulation
2.6.8. Tx to Rx isolation
2.7. Conclusion
3. Plutosky
3.1. Hardware
3.2. Firmware
3.3. Typical test setup
3.4. Port impedance
3.5. RX tests
3.5.1. Rx Frequency response
3.5.2. Rx Gain
3.5.3. Rx Bandwidth filter response
3.5.4. Rx Noise figure
3.5.5. Rx Spurious emissions
3.5.6. Rx Spurious reception
3.6. TX tests
3.6.1. Tx Frequency response
3.6.2. Tx Gain
3.6.3. Tx Filter bandwidth response
3.6.4. Tx LO leakage and Image
3.6.5. Tx Harmonics
3.6.6. Tx Spurious emissions
3.6.7. Tx (baseband) intermodulation
3.6.8. Tx to Rx isolation
3.6.9. Maximum output power
3.7. Conclusion
4. Comparison
4.1. TX impedance
4.2. RX impedance
4.3. TX Frequency Response
4.4. RX Frequency Response
5. Terms of Use
5.1. Scope
5.2. License
5.3. Attribution Requirement
5.4. Figures and Plots
5.5. Data and Measurement Results
5.6. Code and Scripts
5.7. No Endorsement
5.8. Trademarks
5.9. Changes